§Elements
If points are close to each other, only the 1st is displayed, therefore more signs,
, will be zoomed lower!. If an area is densely populated with elements (starting at a certain depth), then the appearing signs must be clicked, they then textually indicate other elements in the area..


If elements are switched off because the zoom depth is not sufficient, but if they are less than 50 elements, the word
OFF (or the number in ´Displayed´) can be clicked and the elements all are displayed

§Zooms
zoom in ALWAYS over the center of the picture..

Before you zoom, you should push the desired center into the center of the picture..

To do this, somewhere in the picture, keep the left mouse button pressed outside of a sign and with visible hand,
push the desired target point into the center, then release the left button and zoom in deeper!

First continue zooming when the picture is completely assembled !!!

Alternatively: without holding down the left mouse button, move over the desired center point, there double-click with the left mouse button.. Then this point is zoomed to the center AND at the same time one step inside..

The first option is particularly suitable for fast zooming in using sliders, so if you want to quickly zoom in on a city, for example, from a country overview..

Please note: slow network connections can lead to error messages if the zooming is too fast, as googlemap will not follow!. In this case call again and zoom slower..

§No overlay
If the Internet connection is very slow (eg on the go with a mobile phone) or if you move too fast multiple times or
zooms in, if the setup is not finished yet it happens that no impressions occur.. Then simply click on
´Refresh all overlays´ and the GIS elements in this pane will be displayed.


meinwomo, 2008-06-06